Jump to content

wildebill308

Members
  • Content Count

    8191
  • Joined

  • Last visited

  • Days Won

    5

Everything posted by wildebill308

  1. Just wondering if the TVs were set up properly and did you do a channel search after each change. Bill
  2. You may be SOL. RV water systems are not made to run at hi preshure. That is why you have to run waterpreshure regulators. This is about as good as you can find. 4 GPM at 55 PSI https://www.pentair.com/content/pentair/en/applications/enjoying-water/rv/water-delivery/4048_high_flow_pump.html Bill
  3. The big problem with the socialist state of Kalifornia is "do as I say not as I do" Last time I was out there they had a major drought going on. Not one water restriction in place, in fact all the towns along 99 were watering the center and sides of the road. They were on tv moaning about the drought but watering the freeway. Bill
  4. Carl, in Main, Mcdonalds sells lobster rolls. Bill
  5. Well I don't do the all you can eat places as much but I haven't found a bad place of the ones we have been to in Providence on Federal hill, like Siena, or Camille's. If you want old school try Aunt Carrie's it is a 1920s era clam shack at,1240 Ocean Rd, Narragansett, RI 02882. Bill
  6. This is what the OP said. Hope we hear back from the OP. Bill
  7. I looked it up it is sold by Eternabond, the tape people. Their site wouldn't open the MSDS sheet so I could see what was in it. I just never heard that term used for solvent. Well actually I am qualified to do that type of fiberglass repair. This might be a good idea as it gives the OP some idea of cost and options. My main concern is what did they do to stick the edges down to the plywood sub structure. Will the edges stay down and not separate even with the RVArmor over it. Bill
  8. That is amazing. I would bet if you measure the difference between the major manufactuers for this tire the differences in diameter will be more than 1.1inch. Why don't you adjust the stop in your steering so it can't hit the airbag? Bill
  9. Spooks535, do you have a generator? Have you been able to run it? It probably uses the house batteries so you might be able to use the switch that connects the 2 battery systems together (with the coach running) and start the generator. This will give you the equivalent of shore power. Richard, with out 12V power the gas valve won't open and you won't get any spark from the igniter. Yes just like the water heater if it doesn't ignite after a set number of tries you have to turn the main switch off and try again. Spooks535, Don't try to light the water heater till you have water in the tank, but that is one more thing to try when you get set up. You need 12V for this to.😄 Bill
  10. I realey don't see that big of a problem. The 275/80 is 1.1 inch taller. It also turns 14 rpm less in a mile. This is handey for comparing tires https://tiresize.com/comparison/ Bill
  11. What is this winterized thing? Bill
  12. Roland, You are leaving just as the weather is improving. We are talking about going back to the Ford Museum on our way East this May. Bill
  13. Welcome to the forum. Like Kay said without 12V power nothing works. Once you get plugged in you may find the fridge will work because your system should pass 12V power to all your 12V requirements and charge the battery. Check the water level in the battery's. Bill
  14. The best way to repair this would be to take that trim strip off. clean all the sealant off the joint(I assume there is a joint under the trim piece). I would sand about 3" on both sides of the joint. Then apply a fiberglass repair to the joint. This will get you a lot closer to the original height and the roof will drain better. What is your skill set? have you ever worked with fiberglass? Have you ever done fiberglass repair using resin and fiberglass cloth or matt? I would use acetone and a scotchbrite pad for cleaning the surface. I have never used EternaClean and don't know what a "hot solvent" is. I would definitely use acetone resistant gloves. If you don't feel comfortable doing it yourself I would look for a place that repairs fiberglass boats and see what they would charge. Bill
  15. Welcome to the forum. Yes a professional inspection is always a good idea. Bill
  16. Just a heads up for those reading this latter, earlier someone talked about overnighting in Palo Duro Canyon. Yes you can but it's a long way off the main roads and the campground is in the bottom of the canyon. The road in/out is intimidating to some and probably an hour out of your way. I like Oasis or Overnite RV Park or Big Texan RV Ranch. For those on the cheap you could look at the truck parking behind Big Texan. Bill
  17. True, welcome to the forum and thank you for your service. Bill
  18. I know you go East on I-40 for a while, where do you turn North? What roads do you use? Bill
  19. Where are you headed this weekend? Bill
  20. Welcome to the forum. Bill
  21. Joe is right. There are as many ways to do it as manufactuers. I am not shure I have seen any 2 the same. Bill
  22. I am glad they are back open. They had been closed because of flooding. Congratulations on the new coach. Bill
  23. Tell me about it I made reservations last year for this year in Maine and Ithaca NY. Some places like the Grand Canyon are hard to get good reservations period. Bill
  24. Keep your serial number handy, you will need it whenever you talk to a Cummins parts guy. What site did you use? https://quickserve.cummins.com/info/index.html This is the same site the dealer looks at to find information on your engine based on the serialnumber. Bill
×
×
  • Create New...