desertdeals69

I believe the engine port is used for programming the trans. I know they used it to change the speedo output of the trans when I change rearend ratio.

We did ours with cork backed bamboo.

Have you tried Gamblers in Quartzite (open only during the winter) or Walts in Pomona? I think i have seen completed doors there.

Is the garage already built or still in planning stages? If not built I would raise the foundation so the driveway would be more level. I have a little hump at the beginning of my driveway to keep the water that comes down the street from coming in the driveway. My driveway is 30 ft wide and 55 ft long and my garage is 32x64 ft with a 14 ft high door and 15 ft interior. If you can't raise the foundation maybe you could slope the driveway down at the beginning and slope it up as it enters the garage.

What exactly are you needing information on?

Its going to be difficult to match as Ernie stated. You might use a contrasting color and change a few of them in a random fashion.

Are you trying to match or replace completely?

Rich, when I installed relays for all my rear lights the power to the relays comes from the coach batteries to even out the load at night between the headlights and tail lights. It has a separate relay for each light and I use circuit breakers.

Read the faults at the keypad.

Thousand Trails has Natchez Trace campground in Hohenwald, Tn.

Check the rpm for the different hp ratings. If the torque is the same actual performance would be the same or very close.

You will need a separate switch for each one.

The state of Arizona doesn't think its safe, they require that insurance companies to replace windshields at no cost to the insured.

Its the box that three sets of big wires go to. It may have a name and description on it.

There are several different residential refrigerators that will work. Not only is a pure sine wave is recommended but also adequate batteries to keep is running.

Some states its not legal to drive with a broken windshield. I have seen windshields crack from jacking in such a way as to twist the frame.

I would try a different power supply or wire direct from the receiver to the tv.

I have limited space so a reel of any type won't fit. I use a heavy duty hose hanger for my 50 amp cord and extension and another hanger for my 20 amp 75 foot and 30 amp and 50 foot extension.

From Thousand Trails Whalers Rest campground happy 4th of July to everyone.

Are you looking for the aluminum extrusion or the vinyl?

I would check with the mfg to see if they have run into this before. It may be the correct one for the chassis but not for your model of coach.

Like Herman said it should be easy to find. On the compressor there should be numbers stamped on a plate. Take the compressor and dryer off and go to a NAPA store and they can match it up. Every time we have a similar situation in our shop thats what we do.

I use the old standby, Carefree.

Weigh the front and rear axles, then use the chart to determine the correct pressure.

I have the same. Surge Guard hard wire. Works fine with 50 or 30 or 20 amp.